To measure current, you must first prepare the nRF7002 EBII.
To measure current in the VBAT domain, put P10 in series with the load and cut solder bridge SB10. To restore normal nRF7002 EBII function after measurement, apply a jumper on P10 or short solder bridge SB10.
Figure 1. Preparing the nRF7002 EBII for current
measurements
Note: If you want to measure current in the VDDIO domain, you must change the connector and
solder bridge used, see Components for current measurement on VDD and VBAT and Solder bridge configuration.