The nRF7002 DK is a hardware development platform used to design and develop Wi-Fi® 6 applications. The Development Kit (DK) supports the development of low-power Wi-Fi applications and enables Wi-Fi 6 features like Orthogonal Frequency Division Multiple Access (OFDMA), Beamforming, and Target Wake Time.
Note: The HTML rendition of this document corresponds to the latest version only.
All relevant versions are available as PDF attachments of this document.
The DK combines the Wi-Fi 6 capabilities of the nRF7002 companion Integrated Circuit (IC) with the nRF5340 System on Chip (SoC).
Key features
- nRF7002 Wi-Fi companion IC
- Dual-band 2.4 GHz and 5 GHz Wi-Fi 6
- Compatible with IEEE 802.11ax (known as Wi-Fi 6) and earlier standards IEEE 802.11a/b/g/n/ac.
- 20 MHz wide channels, 1x1 (SISO) operation and up to 86 MHz 802.11 PHY rate
- Open-source Wi-Fi driver - L2 Network Technologies layer-compatible
- SPI or QSPI host interface, 3-wire or 4-wire coexistence interface
- Secure, 64-word One Time Programmable (OTP) memory with logical and voltage-level based protection mechanisms
- nRF5340
SoC, with support for the following additional wireless
protocols:
- Bluetooth® Low Energy
- Near Field Communication (NFC)
- 802.15.4
- Thread®
- Zigbee®
- ANT™
- 2.4 GHz proprietary
- Onboard 2.4 GHz and 2.4/5 GHz antennas
- NFC antenna
- An optional 32.768 kHz crystal (X2) for higher accuracy and lower average power
- Microwave coaxial connector with switch (SWF) RF connector for direct RF measurements
- User-programmable LEDs (2) and buttons (2)
- SEGGER J-Link on board programmer/debugger
- UART interface through a virtual serial port
- Pins for measuring power consumption
- 1.8 V power supply from Universal Serial Bus (USB) or external Lithium-polymer (Li-Poly) battery
- 3.6 V power supply from USB or external Li-Poly battery to the VBAT of the nRF7002 companion IC
For access to firmware source code, hardware schematics, and layout files, see www.nordicsemi.com.