The nRF7002 Expansion Board (EB) is used to provide Wi-Fi® connectivity to compatible development or evaluation boards through the nRF7002 Wi-Fi 6 companion Integrated Circuit (IC).
Note: The HTML rendition of this document corresponds to the latest version only.
All relevant versions are available as PDF attachments of this document.
The EB has a Printed Circuit Board (PCB) edge connector that can be used with a compatible development board such as the Nordic Thingy:53™ IoT prototyping platform. There are castellated holes on the side of the board that allow the EB to be used as a breakout board that can be soldered to other PCB assemblies.
Key features
- nRF7002 Wi-Fi companion IC
- Dual-band 2.4 GHz and 5 GHz Wi-Fi 6
- Compatible with IEEE 802.11ax (known as Wi-Fi 6) and earlier standards IEEE 802.11a/b/g/n/ac
- 20 MHz wide channels, 1x1 (SISO) operation and up to 86 MHz 802.11 PHY rate
- Open-source Wi-Fi driver – L2 Network Technologies layer-compatible
- SPI or QSPI host interface, 3-wire or 4-wire coexistence interface
- Secure, 64-word One Time Programmable (OTP) memory with logical and voltage-level based protection mechanisms
- Onboard dual-band 2.4/5 GHz antenna
- PCB edge connector compatible with the Nordic Thingy:53
- Castellated edge holes to allow soldering EB to other PCB development boards
- Microwave coaxial connector with switch (SWF) RF connector for direct RF measurements
For access to firmware source code, hardware schematics, and layout files, see www.nordicsemi.com.