GPS receiver operation is time multiplexed with the LTE modem, and GPS and QZSS position can be received while the LTE modem is in RRC Idle mode, power saving mode (PSM), or completely deactivated.

The application processor is the system master and responsible for starting and stopping the GPS receiver. GPS can be run standalone or concurrently with QZSS. The GPS and QZSS reception can be configured through the GNSS interface API.

Note: For details regarding the GNSS API, refer to nRF Connect SDK API documentation.

Key features of the GPS receiver are as follows:

  • GPS L1 C/A reception
  • QZSS L1 C/A reception
  • Optimized for low-power and low-cost IoT applications
  • Modes of operation:
    • Single shot
    • Position fix per fixed interval, configurable to a value between 10 s to 65536 s: first start with cold start, sequential fixes with hot start if interval less than 65536 s and enough satellites have been found in the first start
    • Continuous tracking
  • Power saving mode:
    • Duty-cycled continuous tracking operation
  • One pulse per second (1PPS) signal:
    • A pulse repeating once per second, accurately synchronized to coordinated universal time (UTC) full seconds
    • For more details on 1PPS programmability and power vs. accuracy trade-offs, see GNSS API documentation
    • Available on device COEX1 pin
      • For more details, see LTE modem, coexistence interface
  • Antenna interface:
    • External low-noise amplifier (LNA) with SAW filter recommended on the GPS antenna input
    • Dedicated GPS antenna, or shared antenna with LTE
    • GPS antenna pin is DC grounded
Note: There must be minimum 27dB attenuation to out of band power to avoid blocking high power RF signals to GPS receiver input. This can be achieved by using a SAW filter, for example, at the external LNA output.

Electrical specification

The following is a summary of GPS receiver performance parameters.

Table 1. Common typical conditions
Condition Value
Environment Open sky
Temperature 25°C
GPS sleep clock source TCXO

Note: Local and temporal conditions might lead to considerable variation in TTFF, positioning accuracy, 1PPS signal accuracy.

The figures in the following table assume the use of an external low-noise amplifier (LNA) with SAW filter.

Table 2. GPS electrical specification
Symbol Description Value Unit
Sensitivity, cold Acquisition sensitivity, cold start -145.5 dBm
Sensitivity, hot Acquisition sensitivity, hot start -147 dBm
Sensitivity, tracking Tracking sensitivity -155 dBm
TTFF, cold Time to first fix (TTFF), cold start 36 s
TTFF, hot TTFF, hot start 1.3 s
Accuracy, 2D, periodic Positioning accuracy (CEP50), periodic tracking 5 m
Accuracy, 2D, continuous Positioning accuracy (CEP50), continuous tracking 3 m
1PPS accuracy 1PPS signal accuracy, continuous tracking ±40 ns