nRF54L15 Engineering B Errata

nRF54L15 Engineering B Errata
Revision history
New and inherited anomalies
[1] CCM: MAC error is returned if MDATA size is slightly larger than MLEN
[6] RADIO: Spectrum of transmitted signal is not optimal for 802.15.4
[7] UARTE: RXD.AMOUNT is not updated after RXFLUSH if FIFO is empty
[8] SPIM: Wrong data is transmitted on MOSI
[10] SPU: PERM and FEATURE registers cannot be locked
[13] KMU: Provision task is not ignored when KMU is busy
[16] VPR: Cleared EVENTS are triggered again on the next CNT0 event
[17] VPR: Bus faults during hibernate save sequence are ignored
[18] VPR: Subsequent VPR hibernate sleeps might fail to save ra
[20] CLOCK: RADIO payload is not transmitted
[21] SPIM: MOSI line toggles after transmission ends
[22] TIMER: EVENTS_COMPARE[n] event is not generated
[23] RRAMC: READY and READYNEXT events are generated when CPU wakes up
[24] TIMER: EVENT_COMPARE is not generated when using PPI
[25] TIMER: EVENT_COMPARE[n] is not generated
[26] DPPI: PPIB between domains uses wrong security attribution
[30] CLOCK, GRTC: GRTC operates incorrectly at low temperature
[31] POWER: Current consumption is higher than expected in sleep
[32] POWER: Regulators have incorrect trims
[33] RADIO: GPIOs can exhibit radiated emissions
[37] POWER: Current consumption might increase after pin reset or power cycle
[38] CPU: CPU can malfunction after sleep
[39] CLOCK: Device can behave erratically after XOSTART
[40] RADIO: Band edge transient power is high with range extender
[41] RADIO: Sensitivity is degraded on n*32 MHz channels
[44] EASYDMA: DMA.RX.AMOUNT is not updated with bytes count after match event
[47] POWER: Device resets while debugging in System OFF mode
[48] RESET: RESETREAS register might show an additional wakeup source after reset
[49] RADIO: First bits of on-air packet are not correct
[50] RRAMC: SPU00 incorrectly reports that RRAMC has DMA
[54] SPIS: SDO is configured as an input when SPIS is idle
[59] EGU: EGU uses incorrect security attribution
[63] RESET: Soft reset might not fully reset the device
[100] GPIO: Pins with analog functionality might be shorted together during power-on reset
[102] CCM: Operation fails when CCM MAC length is set to 0
[105] TWIM: Peripheral becomes unresponsive when disabled during clock stretching
[111] SAADC: Output data is incorrect when noise shaping is used
[114] GPIO: Current consumption increases when Wake on pin is used

Back to home page