The pin assignment figure and tables describe the pinouts for the device. There are also recommendations for how the GPIO pins should be configured, in addition to any usage restrictions.
| Pin number | Pin name | Type | Description |
|---|---|---|---|
| 1 | VSS | Power | Ground |
| 2 | ANT1 | RF I/O | First antenna interface |
| 3 | ANT2 | RF I/O | Second antenna interface |
| 4 | MODE | Digital IN | TX power mode control |
| 5 | VDD | Power | Supply voltage |
| 6 | VDD | Power | Supply voltage |
| 7 | RX_EN | Digital IN | RX mode enable |
| 8 | ANT_SEL | Digital IN | Antenna select |
| 9 | TX_EN | Digital IN | TX mode enable |
| 10 | TRX | RF IO | Transceiver interface |
| 11 | PDN | Digital IN | Power-down, active low |
| 12 | SCK | Digital IN |
SPI clock Connect to VSS if SPI interface is not used |
| 13 | MOSI | Digital IN |
SPI data in Connect to VSS if SPI interface is not used |
| 14 | MISO | Digital OUT |
SPI data out Leave unconnected if SPI interfaces is not used |
| 15 | CSN | Digital IN |
SPI chip select, active low Connect to VDD if SPI interface is not used |
| 16 | VSS | Power | Ground |
| DAP | VSS | Power | Ground |