Power off the nPM Controller on the nPM1300 EK by
disconnecting the Universal Serial Bus (USB) cable on J4.
Connect the nPM EK pin header on the nPM Fuel Gauge Board to the to
the EXT BOARD socket on the EK.
Note: To ensure correct operation and prevent malfunction,
make sure edge connectors P1 and P2 on the nPM Fuel
Gauge Board align correctly with their respective sockets P20 and
P21 on the EK.
Power on the nPM Controller on the EK by reconnecting the USB cable on
J4.
Select nPM1300 Evaluation Kit on
the left-side panel in the nPM PowerUP app.
Select Profile Battery to profile your battery and
generate a battery model.
Follow the instructions provided in the Profile Battery wizard and refer to
Using the nPM1300 and nPM1304 Fuel Gauge for further guidelines on battery
profiling.
Warning:
The heat sink on the Fuel Gauge Board
can become hot during battery profiling. Allow the device to cool down
before handling it post-profiling.