BUCK1 not used

nPM6001 EK Hardware

nPM6001 EK Hardware
Revision history
Minimum requirements
Kit content
Hardware description
Block diagram
Power supply
Output connections
Software control
Level shifter
Software library and sample
I/O pins
READY
N_INT
GPIOs
Enable (EN)
BUCK mode selection
Jumpers
BUCK1 not used
BUCK2 not used
Configuration options
Evaluation measurements
Preparing for measurements
Power-on behavior
Measuring static parameters (steady state)
Measuring load transient
Glossary
Recommended reading
Legal notices

Use P17 to configure the nPM6001 EK if BUCK1 is not used. In this configuration, BUCK1 output must be connected to VIN.

Figure 1. BUCK1 configuration

BUCK1 configuration

Back to home page