Connector interface

Access to the nRF7002 EK General-Purpose Input/Output (GPIO)s is available from headers of the connectors P7–P10 on the back of the board.

The following is an overview of the Evaluation Kit (EK) connector functions.

• The P1 and P7 connectors provide access to ground and power on the nRF7002 EK.
• The P2 and P8 connectors provide access to the analog signals of the DK. These signals are not used on the EK.
• The P3 and P9 connectors provide access to the digital signals of the DK. These are used on the EK as control signals for the nRF7002 companion IC.
• The P4 and P10 connectors provide access to the digital signals of the DK. These are used for QSPI/SPI communication to the nRF7002 companion IC.

The following figure shows the Arduino signals routing on the nRF7002 EK.

Figure 1. Arduino signals routing on the nRF7002 EK