| Enumerator |
|---|
| OT_ERROR_NONE | No error.
|
| OT_ERROR_FAILED | Operational failed.
|
| OT_ERROR_DROP | Message was dropped.
|
| OT_ERROR_NO_BUFS | Insufficient buffers.
|
| OT_ERROR_NO_ROUTE | No route available.
|
| OT_ERROR_BUSY | Service is busy and could not service the operation.
|
| OT_ERROR_PARSE | Failed to parse message.
|
| OT_ERROR_INVALID_ARGS | Input arguments are invalid.
|
| OT_ERROR_SECURITY | Security checks failed.
|
| OT_ERROR_ADDRESS_QUERY | Address resolution requires an address query operation.
|
| OT_ERROR_NO_ADDRESS | Address is not in the source match table.
|
| OT_ERROR_ABORT | Operation was aborted.
|
| OT_ERROR_NOT_IMPLEMENTED | Function or method is not implemented.
|
| OT_ERROR_INVALID_STATE | Cannot complete due to invalid state.
|
| OT_ERROR_NO_ACK | No acknowledgment was received after macMaxFrameRetries (IEEE 802.15.4-2006).
|
| OT_ERROR_CHANNEL_ACCESS_FAILURE | A transmission could not take place due to activity on the channel, i.e., the CSMA-CA mechanism has failed (IEEE 802.15.4-2006).
|
| OT_ERROR_DETACHED | Not currently attached to a Thread Partition.
|
| OT_ERROR_FCS | FCS check failure while receiving.
|
| OT_ERROR_NO_FRAME_RECEIVED | No frame received.
|
| OT_ERROR_UNKNOWN_NEIGHBOR | Received a frame from an unknown neighbor.
|
| OT_ERROR_INVALID_SOURCE_ADDRESS | Received a frame from an invalid source address.
|
| OT_ERROR_ADDRESS_FILTERED | Received a frame filtered by the address filter (whitelisted or blacklisted).
|
| OT_ERROR_DESTINATION_ADDRESS_FILTERED | Received a frame filtered by the destination address check.
|
| OT_ERROR_NOT_FOUND | The requested item could not be found.
|
| OT_ERROR_ALREADY | The operation is already in progress.
|
| OT_ERROR_IP6_ADDRESS_CREATION_FAILURE | The creation of IPv6 address failed.
|
| OT_ERROR_NOT_CAPABLE | Operation prevented by mode flags
|
| OT_ERROR_RESPONSE_TIMEOUT | Coap response or acknowledgment or DNS, SNTP response not received.
|
| OT_ERROR_DUPLICATED | Received a duplicated frame.
|
| OT_ERROR_REASSEMBLY_TIMEOUT | Message is being dropped from reassembly list due to timeout.
|
| OT_ERROR_NOT_TMF | Message is not a TMF Message.
|
| OT_ERROR_NOT_LOWPAN_DATA_FRAME | Received a non-lowpan data frame.
|
| OT_ERROR_LINK_MARGIN_LOW | The link margin was too low.
|
| OT_ERROR_INVALID_COMMAND | Input (CLI) command is invalid.
|
| OT_NUM_ERRORS | The number of defined errors.
|
| OT_ERROR_GENERIC | Generic error (should not use).
|