Registers

Start the ADC and prepare the result buffer in RAM

Take one ADC sample, if scan is enabled all channels are sampled. This task requires that SAADC has started, i.e. EVENTS_STARTED was set and EVENTS_STOPPED was not.

Stop the ADC and terminate any on-going conversion

Starts offset auto-calibration

Subscribe configuration for task START

Subscribe configuration for task SAMPLE

Subscribe configuration for task STOP

Subscribe configuration for task CALIBRATEOFFSET

The ADC has started

The ADC has filled up the Result buffer

A conversion task has been completed. Depending on the mode, multiple conversions might be needed for a result to be transferred to RAM.

A result is ready to get transferred to RAM.

Calibration is complete

The ADC has stopped

Last results is equal or above CH[n].LIMIT.HIGH

Last results is equal or below CH[n].LIMIT.LOW

Publish configuration for event STARTED

Publish configuration for event END

Publish configuration for event DONE

Publish configuration for event RESULTDONE

Publish configuration for event CALIBRATEDONE

Publish configuration for event STOPPED

Publish configuration for event CH[n].LIMITH

Publish configuration for event CH[n].LIMITL

Enable or disable interrupt

Enable interrupt

Disable interrupt

Status

Enable or disable ADC

Input positive pin selection for CH[m]

Input negative pin selection for CH[m]

Input configuration for CH[m]

High/low limits for event monitoring a channel

Enable burst mode

Resolution configuration

Oversampling configuration. OVERSAMPLE should not be combined with SCAN. The RESOLUTION is applied before averaging, thus for high OVERSAMPLE a higher RESOLUTION should be used.

Controls normal or continuous sample rate

Data pointer

Maximum number of buffer bytes to transfer

Number of buffer bytes transferred since last START, updated after the END or STOPPED events

Number of buffer bytes transferred since last START, continuously updated